BPT PXWDTCB Radio Curtain Detector White 846EA-0090

€165.96

Tax included

BPT Came dual technology radio curtain effect detector with the following features:

Power supply No. 1 3V Lithium battery (CR123A)
Frequency (MHz) 433.92/868.65
Max. absorption (mA) 50
Standby absorption (uA) 25
Radio signal strength (dBm) <10
Detection range 5 meters
Coverage of the 2 beams Lens 79° thickness 7.5°
Microwave frequency (GHz) 24
Microwave sensitivity High/Low via dip-switch
Free air range (m) 200 (@868.65 MHz) - 100 (@433.92 MHz)
Operating temperature range: -25 /+50°C
Degree of protection IP43
Standards: EN50131-2-4 Grade 2, EN50131-5-3, EN50131-6: Type C, EN50130-5, Environmental Class III
Body color: white

Available

Politiche per la sicurezza

(modificale nel modulo Rassicurazioni cliente)

Politiche per le spedizioni

(modificale nel modulo Rassicurazioni cliente)

Politiche per i resi

(modificale nel modulo Rassicurazioni cliente)

PXWDTCB is a volumetric radio curtain effect sensor suitable for indoor and outdoor protected environments.

An additional 2 wired devices (e.g. shutter contacts or other sensors) can be connected for radio transmission of alarms.

The sensor also has an anti-opening device and an anti-tear device. If the container is opened or torn from the mounting surface, the sensor will activate the alarm.

The sensor is suitable for installation on the ceiling, example door jamb, window or wall but only indoors.

INSTALLATION: Before installing the sensor, make sure that there are no causes in the environment that may affect the proper operation of the sensor.

For example:

Direct exposure to sun and rain
Surfaces subject to vibration
Presence of animals
Heat sources

ASSEMBLY: Turn the flap, unscrew the screw and remove the bottom of the sensor by helping with a screwdriver. Route the cable from other devices to the terminals. Orient the sensor to the desired position and secure the sensor base with screws and dowels (provided). Close the sensor back up.

PROGRAMMING: Insert the battery. After powering the sensor, the red and green LEDs will light alternately for about ten seconds until initialization is complete. Proceed with the adjustments of the coverage of the room to be protected.