Urmet base with siren and flashing light 1043/512

It is a device with an integrated siren and flashing light, and can be used either as an independent actuation device or with a detector from the 500 series digital line (codes 1043/501, /502, /503, /504).

 

The base when connected to a control panel connects directly to the loop (no external power supply required) and takes on an address.

 

INSTALLATION:

To attach the base, proceed as follows:

• Rotate the plastic disk and separate it from the addressed base
• Attach the plastic disk to a flat surface by taking advantage of the "breakout" slots and using appropriate dowels and screws
• Hook the base onto the plastic disk
• Insert the locking screw "A" with the plastic disk into the base and screw it down
• Make the electrical connections with the detection line
• Arrange jumpers and microswitches according to the chosen configuration
• Attach, if provided, the detector to the base or it is necessary to mount the front cover to cover the area related to contacts and connections.
• When the base is connected to a fire alarm output use only the front cover; do not attach any detector to the base.