Binary input terminal Abb KNX BE/S 8.20.2.1, 8 channels, KNXE003

On the front side there are buttons for manual operation with which you can simulate the input status. The yellow LED displays the current input status.

The device is ready for operation after connecting the bus voltage. The binary input terminal is parameterized via ETS. The connection to the KNX is established via the bus connection terminal on the front.

Characteristics:

• Bus voltage 21...32 V DC
• Current consumption, bus max. 7 mA
• Power consumption, bus max. 150 mW
• Power loss, bus max. 150 mW
• Inputs Quantity 8
• Scanning voltage Un 35 V, pulsed
• Scanning current In 0.1 mA
• Scanning current In on activation max. 355 mA
• Max. permissible line length 100 m at 1.5 mm²
• KNX connections via connection terminal to the bus
• Inputs via screw terminals with combined header
• Screw terminal Screw terminal with combination head (PZ 1) 0.2...4 mm² fibrillar, 2 x (0.2...2.5 mm²) 0.2...6 mm² single wire, 2 x (0.2...4 mm²)
• Cable end sleeve without/with Plastic sleeve without: 0.25...2.5 mm² with: 0.25...4 mm²
• TWIN cable end sleeves 0.5...2.5 mm².
• Contact pin length at least 10 mm
• Maximum tightening torque 0.8 Nm
• Grille 6.35
• Type of protection IP 20
• Protection class II
• Mounting On 35 mm transport rails
• Weight 0.2 kg
• Color/housing Plastic, gray
• KNX approvals according to EN 50 090-1, -2 Certificate
• CE mark According to low voltage and EMC directives