Sicom Dali Push Led Power Supply Driver 60W 800-2000mA 5601321

Short-circuit behavior of the output:

• In the event of a short circuit on the LED output, the LED output will be turned off.
• After restarting the LED driver, the output will be turned on again
• Restart can be done by network restoration or by interface
  
   

No-load operation of the output:

• The LED driver will not be damaged during idle operation
• The output will be turned off and thus de-energized
• If an LED load is connected, the device must be restarted before the output is activated again
  
   

Output overload protection:

• If the output voltage range is exceeded, the LED drivers will turn off the LED output
• After restarting the LED driver, the output will be activated again
  
   

Hot plug-in output: For LED protection, if you connect the LED to the output of the powered driver, the LED will not turn on and the device will need to be restarted.

 

Output parameters:

• DIP Swich output current adjustment with 16 levels
• Output current ripple LF ±2%.
• Output current accuracy ±2%
• Linear adjustment ±1%
  
   

Input parameters:

• Rated input voltage: 200-240V AC DC
• Rated input voltage: 180-264V AC DC
• Input frequency: 50/60 Hz
• Inrush current: 9.1A
  
   

Safety:

• Voltage withstand: I/PO/P(LED):3750 V AC, O/P(LED)-O/P(DIM):500 V AC, I/PO/P(DIM):500 V AC, I/P-DALI: 500 V AC
• Mains overvoltage capability: LN:2KV
• Leakage current: <0.7 mA (230V AC and full load)
• Insulation resistance: I/PO/P:100 Mÿ/500 V DC/25°C/70% RH
  
   

Environment and durability:

• Operating temperature: -20/+45 degrees
• Housing temperature: 90 degrees
• Operating humidity: 5-85% RH, non-condensing
• Acoustic noise: <25 dB (30 cm, full load)