Circulator DAB VS 16/150M wet rotor 60182216H

DAB VS 16/150M wet rotor circulator 1 1/2 inches 150mm 60182216H

€219.58

Tax included

DAB VS 16/150M wet rotor circulator for circulating hot water in closed and pressurized or open vessel type domestic central heating and air conditioning systems.

Center distance 150mm
Pump connections 1 1/2 inches

Available

Politiche per la sicurezza

(modificale nel modulo Rassicurazioni cliente)

Politiche per le spedizioni

(modificale nel modulo Rassicurazioni cliente)

Politiche per i resi

(modificale nel modulo Rassicurazioni cliente)

Pump for circulating hot water in domestic central heating and air conditioning systems of closed and pressurized or open vessel type.

Construction features

Single body formed by the hydraulic part made of bronze and wet rotor motor
Die-cast aluminum motor case
Technopolymer impeller
Hardened stainless steel motor shaft mounted on graphite bushings lubricated by the pumped liquid
Stainless steel rotor sleeve, stator sleeve and end flange
Ceramic thrust ring, silicone seal rings and brass air vent plug
Two-pole, asynchronous, wet-rotor motor is resistance protected and requires no overload protection
Three-speed operation
Degree of protection: IP 44
Insulation class: F
Cable entry: PG 11
Installation: with the motor axis horizontal
Series voltage: single-phase 230 V / 50 Hz

Features:

50Hz power supply 1x230 V ~
Wheelbase 150mm
Pump connections 1 ½ inches
Outlets on request Brass 1/2 F - 3/4 F - 1 F Copper d22 and d28
Max. power 41W
In 0.19A
Operating range: 0.6 to 3.7 m3/h with head up to 6 meters
Liquid temperature range: -10°C to +85°C for sanitary use and +110°C for other uses
To avoid limescale phenomenon, it is advisable not to exceed 65°C and to provide an anti-scale system when the water hardness degree exceeds 15 degrees French
Pumped liquid: clean, free of solids and mineral oils, not viscous, chemically neutral, close to the characteristics of water (glycol max 30%)
Maximum operating pressure: 10 bar (1000 kPa)
Installation: with HORIZONTAL MOTOR AXIS
Single body formed by the bronze hydraulic part and wet rotor motor
Die-cast aluminum motor case
Technopolymer impeller
Hardened stainless steel motor shaft mounted on graphite bushings lubricated by pumped liquid
Stainless steel rotor sleeve, stator sleeve and end flange
Ceramic thrust ring
Silicone seal rings and brass air vent plug
Two-pole asynchronous, wet rotor motor is resistance protected and requires no overload protection
Three-speed operation
Degree of protection: IP 44
Insulation class: F
Cable gland: PG 11
Installation: with horizontal motor lasse.