Disconnector Hager 1P 25A 1 module SBN125

Thedisconnector, otherwise called voltage isolator, has the same features of a switch, but on a larger scale: it is, in fact, responsible for closing the flow of energy to the power plants. This serves mainly to ensure the safety of the plant and primarily of the people who work inside since one of its peculiarities is to separate the flow of energy from the working environments. Another peculiarity of this instrument is the ability to detect defects in the electrical flow and isolate them. When the defect is corrected, the disconnector will ensure that the current flows normally again.

Features:

• Hager Series
• Nominal operating voltage 230 Vac
• Rated frequency 50/60 Hz
• Rated insulation voltage 440 V
• Input voltage type 1 AC
• Rated fault withstand current 4000 V
• Rated current In 25A
• Disconnector without neutral
• 1 pole
• 1 module
• Enclosure protection degree IP20
• Total power loss 0.9 W
• Power loss per pole 0.9 W
• Depth 68 mm
• Height 83 mm
• Width 17.5 mm
• Tightening torque 1.8 Nm
• Min. cross-section with flexible cable 1.5 / 10mm²
• Min. cross-section with rigid cable 1.5 / 16mm²
• Misaligned terminal position
• Screw connection
• Operating temperature -20...50 °C
• Pollution degree 2
• Altitude 2000m
• Storage/transport temperature -40...80 °C
• DIN rail mounting