Bticino actuator 2 independent channels 2 DIN modules F411U2

Actuator with 2 independent channels, interlocked for the management of LED lamps, compact fluorescent lamps (CFL), linear fluorescent lamps with electronic transformers, ferromagnetic transformers or motors (in case of relay interlocking). Each channel can switch up to a maximum of 10A. The device incorporates the Zero crossing function for a correct management of energy saving lamps. Configurable through MHSuite or physical configurators; a summary of the main functions that can be implemented is shown below:

• Lights switching
• Motor switching
• Selection of the functioning mode (Master, Slave, Master PUL, Slave PUL)
• Manual selection of the load control mode (with zero crossing, without zero crossing)
• Configuration of contact status when power is restored
• Configuration of the switch-off delay for the Slave device (only in Master/Master PUL mode)

For further details please refer to the "Configuration" section. After connecting the device to the BUS/SCS and to the load, it is possible to control the loads from any control device that is part of the system, suitably configured. It is also possible to control the loads locally using the buttons on the device: a short press activates or deactivates the load.

Features:

• Bticino series
• Power supply from SCS BUS: 27 Vdc
• Operating power supply by SCS BUS: 22 - 27 Vdc
• Power consumption 5 mA (stand-by), 55 mA (max - single loads), 30 mA (max - interlocking)
• Number of outputs: 2x10A
• Operating temperature(0) - (+40) °C
• 460VA ferromagnetic transformers
• 460W geared motors
• 4A linear fluorescent lamps and electronic transformers
• 2 DIN modules
• Voltage 27 Vdc
• Current In 0.055A
• Power (VA) 460VA
• Power (W) 1380W
• Contact type 2